Pages: [1]
Author Topic: C5 a6 2.8 to 2.7t swap  (Read 3315 times)
Lowc5Avant
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4


« on: January 02, 2019, 11:48:58 AM »

Did a swap,  changed ecu out for the 2.7t ecu now trans is stuck in limp mode with code p1841
Tried clearing codes, didnt fix it. ECU is soft coded for the auto trans, and has a bone stock map. Is there anything else I need to do to get the trans out of limp mode?

Any help is appreciated.
Logged
macxxx
Sr. Member
****

Karma: +29/-1
Offline Offline

Posts: 498


« Reply #1 on: January 02, 2019, 11:57:49 AM »

Change the transmission ecu if th ratios are the same , change to automatic trans from 2.7t or swap to manual
Logged
Lowc5Avant
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4


« Reply #2 on: January 02, 2019, 12:01:54 PM »

Can you elaborate slightly on that? The TCM  was good prior to the swap and worked fine so I doubt the swap caused the TCM to go bad, this only became present post swap with the new ECU. manual swap is not in the cards for me at the moment sadly.
Logged
macxxx
Sr. Member
****

Karma: +29/-1
Offline Offline

Posts: 498


« Reply #3 on: January 02, 2019, 12:03:21 PM »

The 2.8 tcm is not compatible with ecu from 2.7t

Logged
Lowc5Avant
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4


« Reply #4 on: January 02, 2019, 12:06:07 PM »

Is there a way around swapping the tcm? Or is that the only way to fix this issue outside of manual swapping or getting a 2.7t auto?
Logged
macxxx
Sr. Member
****

Karma: +29/-1
Offline Offline

Posts: 498


« Reply #5 on: January 02, 2019, 12:09:47 PM »

As i remember ratio is diffrent so uf swap a tcm from 2.7t it will go also in limp mode - we fought with it with my friend and tried diffrent tcm dumps...ut ended with a swap to manual

Maybe you can workaround it modifing tcm dump to adjust ratios but we had no info about maps in it
Logged
Lowc5Avant
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4


« Reply #6 on: January 02, 2019, 12:12:28 PM »

Thanks for the info, I suppose I will attempt to dig deeper into the issue and see what I can come up with.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.017 seconds with 17 queries. (Pretty URLs adds 0s, 0q)