Pages: 1 [2]
Author Topic: Plumb N75 into inltake manifold?  (Read 12028 times)
Blazius
Hero Member
*****

Karma: +89/-40
Offline Offline

Posts: 1277



« Reply #15 on: March 12, 2019, 06:40:30 AM »

I still use K03-026 in my 1.8T (1984cc stroker), 10,4:1 CR, E100, boosting up to 24psi peak. Using this setup for 18 months now.
I'm impressed of how strong this oem turbos are.

Its strong until the shaft literally shatters and destroys the engine. You are literally asking for it with those boost levels. Atleast upgrade to a KO4/hybrid with k16 comp wheel/turbine , to get same boost & better perfomance/flow with  lower shaft speed.
Logged
dal
Full Member
***

Karma: +6/-7
Offline Offline

Posts: 189



WWW
« Reply #16 on: March 12, 2019, 07:57:08 AM »

Its strong until the shaft literally shatters and destroys the engine. You are literally asking for it with those boost levels. Atleast upgrade to a KO4/hybrid with k16 comp wheel/turbine , to get same boost & better perfomance/flow with  lower shaft speed.

Yeah, I'm aware of that. In one or two weeks, I'll start disassembling my car to finish the project. K03 was never in my project, its just that here is Brazil things are so expensive, and in this time I was doing another thins to the car.
Soon I'll be with 400whp, with a proper turbo, etc... if you have instagram, see my project at @a3stroker.
Logged

Audi A3 8L
1984cc stroker - E100 - ME7 wideband converted - 400whp target
Instagram: @a3stroker
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.016 seconds with 17 queries. (Pretty URLs adds 0s, 0q)