Pages: [1]
Author Topic: Paddle Shift  (Read 762 times)

Karma: +0/-0
Offline Offline

Posts: 1

« on: May 06, 2019, 03:42:32 AM »

Hello All.
I was wondering if anyone has had experience of adding gearcut request, and throttle blip via CAN bus into ME7.1.1? From the gear control unit, I am able to assign whatever CAN address, message format etc, that I need to send the the ECU, but obviously need to change the ECU MAP to accept and action it. For reference, the engine in this project is the Audi 4.2 bi-turbo.
Thanks for any help.
Pages: [1]
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 17 queries. (Pretty URLs adds 0s, 0q)