Pages: [1]
Author Topic: I can write to ECU via NefMoto but I can't read ECU  (Read 243 times)
BlackT
Full Member
***

Karma: +7/-2
Offline Offline

Posts: 222



« on: June 01, 2019, 11:52:50 AM »

I have successfully flashed BEX software
Part Number : '8E0909518AH '
SW Version  : '0002'
HW Number   : '0261207941'
SW Number   : '1037366871'
To AWT ECU
Part Number : '4B0906018DH '
Engine ID   : '1.8L R4/5VT
SW Version  : '0004'
HW Number   : '0261207928'
SW Number   : '1037366497'


And tuned that ECU, even NefMoto give me error 'unable to validate memory layout'
https://youtu.be/8OOM5xzTxzw

But I can't read flash. Same problem I have with original ECU that came with car (BEX)
https://youtu.be/6wtay1ydSJ0

Both ECU-s are IMMO off. Also I tryed on an bench with no success

Galleto give me change speed error

Logged
Marty
Hero Member
*****

Karma: +125/-80
Offline Offline

Posts: 1285


« Reply #1 on: June 01, 2019, 02:32:23 PM »

Nefmoto will work just ignore the layout warning or do bootmode. Galletto only works in boot mode iirc
Logged

BlackT
Full Member
***

Karma: +7/-2
Offline Offline

Posts: 222



« Reply #2 on: June 01, 2019, 04:32:22 PM »

I put video im first post. Ignoring waring and still won't read ECU.
When this ECU was on ATW flash, I could read it with galleto without problems.
But now when BEX flash is in it I can't read it.
Same is with BEX original ECU.
Maybe some protection, so it can only read via boot mode
Logged
Marty
Hero Member
*****

Karma: +125/-80
Offline Offline

Posts: 1285


« Reply #3 on: June 02, 2019, 05:43:38 AM »

Possibly. Then that means you're using someone else's file...
Logged

BlackT
Full Member
***

Karma: +7/-2
Offline Offline

Posts: 222



« Reply #4 on: June 02, 2019, 11:37:45 AM »

Did you meam,someone else's file like from some tuning company??  I am using this file, found on this forum
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 16 queries. (Pretty URLs adds 0s, 0q)