Pages: [1]
Author Topic: A3 1,8t ARY/AUQ maf too high readings?  (Read 3550 times)
zax
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 13


« on: November 14, 2019, 03:28:13 PM »

Hello!
I'm currently working on my 1,8t AUQ swapped instead of ARY.
I've removed all air leaks, but there is still problem with too high readings of MAF - 16487 in VCDS, and then it see pressure drop between turbo and Throttle valve... (17705).
I've reverted the stock map, because last owner modified it in the way, so the turbo has blown up Grin
Car has 3,25" DP, removed second o2 sensor, stainless TIP, and removed N249 and N112. I've removed just second oxygen sensor from the program, rest is stock.
There are only 4 wires comes from MAF, and MAF has 5 connectors.
I've bought car with MAF which tells "Signal too low".
I've swapped it into working (but used) one. Car was working perfectly, but after 500 km MAF stopped working. It also shows "Signal too low".
I don't know if the car is murdering MAFs, or it was just an accident.
Here are the test on the new MAF:
http://vaglogi.pl/log-002_115_eg72w.html
I know, that the maximal readings should be around 160-170 g/s, and here after 4000 rpm there is about 224, and it stalls.
Do you have any ideas what to check?
I'll also post the program in other topic to see, what was done in the previous program.
Logged
soul87
Jr. Member
**

Karma: +5/-0
Offline Offline

Posts: 44


« Reply #1 on: November 15, 2019, 01:06:40 AM »

3 Options

1. Maf is defective, for 1.8t only new BOSCH mafs are ok. Any other brands are crap and dont work correctly.
2. There is a hole beetween turbo and engine
3. Someone rescale the MAF in the ecu software .
« Last Edit: November 15, 2019, 01:09:07 AM by soul87 » Logged
zax
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 13


« Reply #2 on: November 15, 2019, 07:36:52 AM »

Hi!
Thanks for the answer.
But I'm afraid to buy new bosch maf if two were broken in that car. Is there normally only 4 wires connected from MAF? I've checked with autodata, and tere is 5V, 14V, groud and 0,x V at te wires and that's correct.
Logged
zax
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 13


« Reply #3 on: November 21, 2019, 11:25:18 AM »

Hi!
I've replaced MAF from Autlog for Bosch one, and all is fine.
Now I can start tuning Grin
Logged
soul87
Jr. Member
**

Karma: +5/-0
Offline Offline

Posts: 44


« Reply #4 on: November 23, 2019, 03:16:54 AM »

Dont blow up Your engine... Wink
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 16 queries. (Pretty URLs adds 0s, 0q)