I have struggled and learned my way to having this flash. NefMoto would not read for reasons I cannot figure out. I was able to replace the serial number in my FTDI cable and use Galletto 1260 to pull this. I am trying to delete all emissions from this file. This XDF i found on here should be the right file, but when i navigate to ESKONF, I only get a 2x7 table that i will hopefully attach a screenshot of. There are no bits like the s4wiki has. I have read that whole page top to bottom probably 3 times and am still unsure whats wrong with my ESKONF. Could someone just open them both and see if i am on the right track?

Also is it possible to tell if the flash has a tune on it? To my knowledge it should be stock, but NefMoto says it cant read the flash due to being tuned.

you have a 1.8T, you have 2 ESKONFs, one for MT 1x7 at 10D82 and one for AT 1x7 at 10D89. Look into according wiki info. You don't have an 2.7T.

xdf table shows decimal values
you can right click on it and change to raw hex view or do that in table params
and/or use any converter to get binary from decimal or hexademical and vice-versa

No problem! I think his advice is what I needed. Going to give it another look after work tonight. Thank you both! I think I was right clicking everywhere but on the numbers!

Engine does not have EGR....