hey guys, didn't want to make a new post for this particular question but I cant seem to fine any answers. I have me7eeprom version 1.31 and 1.40 ive been using right along for quite some time... at least 8 months, I used to be able to read and write eeprom files no problem (one version would work better than the other depending on immo2 or immo3) but recently ive only been able to write eeprom files, I keep getting these error messages when trying to write them, also I have been using the same bench flash setup and power supply right from day one.

C:\>me7_95040.exe --bootmode -wp4 95040_off.bin
Ver: 1.31
Com Port: 4
Baud Rate: 10400
Opening COM4 ... OK
Starting Boot_mode ... uC identification response = 0xC5 (C167 derivatives) ... OK
Sending Loader + MonitorCore ... MonitorCore successfully launched
Initializing registers ... ... OK
Sending EEPROM driver ... OK
Searching Chip_Select pin ... P4.7
Configuring SPI Interface ... OK
Checking EEPROM status ... 0x00F0 ... OK
Writing EEPROM ................................ OK
Verifying EEPROM write ... OK
Closing COM4

C:\>me7_95040.exe --OBD -r -p 4 95040.bin
Ver: 1.31
Com Port: 4
Baud Rate: 10400
Opening COM4 ... OK
Initiating communication ... FAIL. (error=0x01)
Closing COM4


C:\>immo1.exe --OBD -r -p 4 95040.bin
ME7_EEPROM v1.40
COM: 4, Baud Rate: 10400
Opening COM4 ... OK
Initiating communication ... FAIL. (error=0x21007)
Closing COM4

C:\>immo1.exe --bootmode 95040 -wp4 95040_off.bin
ME7_EEPROM v1.40
COM: 4, Baud Rate: 10400
Memory type: 95040, size: 512
Opening COM4 ... OK
Starting Boot_mode ... uC ID response 0xC5: C167CR ... OK
Sending Loader + MonitorCore ... MonitorCore successfully launched
Initializing registers ... OK
Sending EEPROM driver ... OK
Searching Chip_Select pin ... P4.7
Configuring SPI Interface ... OK
Checking EEPROM Status Register ... 0x00F0
Writing EEPROM ................................ OK
Verifying EEPROM write ... FAIL. (error=0x70101)
Closing COM4