Pages: [1]
Author Topic: Please help ecu bricked??  (Read 2818 times)
chicolin
Newbie
*

Karma: +0/-1
Offline Offline

Posts: 7


« on: March 20, 2020, 07:13:50 PM »

Hello every one. So here is my situation i have an 03 audi a4 b6. I purchased a tune online and flashed with mpps v13 all was well. Tunner requested me to send log files. Sent log files and he sent me new updated flash file. I checksum file wth mpps v13 saved file and wrote to my ecu laptop plugged in battery charger set at 14v. mpps finished file flash did the ign off on thing. When ignition was on fans were at full speed and throttle body clicking nonstop. Car wont start and i can not flash back original file to ecu im stuck with no car for work. Any help or am i screwed??
Logged
_nameless
Hero Member
*****

Karma: +323/-449
Offline Offline

Posts: 2693



« Reply #1 on: March 20, 2020, 10:58:11 PM »

mpps has bootmode in the generic drop down tab. youll need to  open the ecu and ground a pin to put it in boot mode. if you dont have a bench flash setup you can use the car to flash it in bootmode but its a clusterfuck
 https://www.youtube.com/watch?v=iY7w-2owzck
that will give you an overview of using mpps in bootmode
Logged

If you are in the market for a tune and would like the ease of downloading and flashing a dyno tested tune for a fair price check out https://instatune.sellfy.store/
_nameless
Hero Member
*****

Karma: +323/-449
Offline Offline

Posts: 2693



« Reply #2 on: March 20, 2020, 11:14:55 PM »

its not really a tuned file. the only thing done was zeroing a bunch of project configuration bits
Logged

If you are in the market for a tune and would like the ease of downloading and flashing a dyno tested tune for a fair price check out https://instatune.sellfy.store/
chicolin
Newbie
*

Karma: +0/-1
Offline Offline

Posts: 7


« Reply #3 on: March 21, 2020, 12:15:39 AM »

Thanks for the reply. I watched the youtube vid you linked. Took apart my ecu and it looks nothing like the one in the video. it has wires and some other chips( attached see pics). Is this stock? will boot mode still work?
Logged
_nameless
Hero Member
*****

Karma: +323/-449
Offline Offline

Posts: 2693



« Reply #4 on: March 21, 2020, 05:02:08 AM »

That's a giac logic board. Shit umm you're gunna need to remove that logic board and install a stock flash chip to fix it
Logged

If you are in the market for a tune and would like the ease of downloading and flashing a dyno tested tune for a fair price check out https://instatune.sellfy.store/
_nameless
Hero Member
*****

Karma: +323/-449
Offline Offline

Posts: 2693



« Reply #5 on: March 21, 2020, 06:05:07 AM »

Thanks for the reply. I watched the youtube vid you linked. Took apart my ecu and it looks nothing like the one in the video. it has wires and some other chips( attached see pics). Is this stock? will boot mode still work?
I have extra ecus I can immo off one and ship it to you. You can have the ecu and just pay for shipping.
Logged

If you are in the market for a tune and would like the ease of downloading and flashing a dyno tested tune for a fair price check out https://instatune.sellfy.store/
chicolin
Newbie
*

Karma: +0/-1
Offline Offline

Posts: 7


« Reply #6 on: March 21, 2020, 10:30:25 AM »

I have extra ecus I can immo off one and ship it to you. You can have the ecu and just pay for shipping.

Thank you. You are a lifesaver.
check pm
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.015 seconds with 16 queries. (Pretty URLs adds 0s, 0q)