Pages: [1]
Author Topic: Load to kPa (vvt maps) - MKV R32 VR6  (Read 3827 times)
ricekikr
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 104


« on: June 04, 2020, 10:43:59 PM »

Edit: MKV R32 VR6 (proj attached on post #3)

Using the data for a standalone. What would be the best way to convert the VVT maps at idle/decel/cruise/WOT. (ie, just go diagonally at it the whole map or just use 109%). Doesn'0t need to be 100% but close enough to save time tuning. Mostly interested in idle and WOT

Does 109% load = WOT or is it just a calculated load?

1. 100+% = WOT
2. 50% = WOT but a low airflow

====
3. Why does the Exhaust VVT jump from a positive > negative > positive same rpm different load? (2nd pic)
4. Why doesn't the values coincide with the Study guide (full advance below 1200rpm then base than advance near redline)? (3rd pic)
« Last Edit: June 05, 2020, 11:21:11 PM by ricekikr » Logged
adam-
Hero Member
*****

Karma: +122/-33
Offline Offline

Posts: 2177


« Reply #1 on: June 05, 2020, 03:56:34 AM »

What ECU?  Single stage VVT should only have -18 and 22, nothing in between.
Logged
ricekikr
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 104


« Reply #2 on: June 05, 2020, 09:06:03 AM »

From a Mk5 R32, full range VVT on int&exh

KFNWSA and KFNWSE are the main maps right? Every other vvt maps are just corrections for various conditions?


==
Will be installed on 3.6 vr6, but couldn't find definition files for it. I believe any 2006+ vr6 have very similar operation and range. Just need something to start on, will tune from there.

Attached OLS proj. Got it somewhere on this site.
« Last Edit: June 05, 2020, 09:10:47 AM by ricekikr » Logged
curamrdan
Full Member
***

Karma: +4/-1
Offline Offline

Posts: 128


« Reply #3 on: June 07, 2020, 03:28:00 PM »

I think you can roughtly load=kpa here.  So 50% is not wot, just cruise area.Highest tree or four rows are same to have some histeresis for WOT.
Also there is set value for reference camshaft angle value(can differ on intake/exhaust), so it will be as zero for your standalone (means mechanical position, vvt not active) and count movement degree from them. So WNWSE(A)APP  values in this file.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 17 queries. (Pretty URLs adds 0s, 0q)