Pages: [1]
Author Topic: ME7EEPROM: No matter what I do, I get error: 0x20B07  (Read 6039 times)
1gcrazy
Full Member
***

Karma: +0/-3
Offline Offline

Posts: 99


« on: April 30, 2020, 02:22:23 PM »

Starting Boot_mode ... FAIL ... No echo, check cable. (error=0x20B07)

I've tried different cables with different ports, I've tried different ecu's, different harnesses, different power supplies, etc. I can't get either of my ebay dumb cables to work with ME7EEPROM.EXE. They were working fine a few weeks ago and then bam, nothing.
Logged
aef
Hero Member
*****

Karma: +69/-46
Offline Offline

Posts: 1567


« Reply #1 on: April 30, 2020, 04:05:43 PM »

where to start....

Is your calbe recognised in device manager and driver is ftdi 2.12.28?
Is nefmoto flasher detecting your cable?
try me7_95040 instead of me7eeprom and post some pictures next time
Logged
adam-
Hero Member
*****

Karma: +122/-33
Offline Offline

Posts: 2178


« Reply #2 on: April 30, 2020, 11:18:31 PM »

Have you put it in a different USB port?
Logged
1gcrazy
Full Member
***

Karma: +0/-3
Offline Offline

Posts: 99


« Reply #3 on: May 15, 2020, 01:02:09 PM »

I got ME795040 to work but now having issues with Vag commander 2.5. This also went down when my original blue cable died. I kept getting SH cables instead of FTDI cables, that ended up being the issue.

So now ME7_95040 works but again, Vag commander 2.5 does not recognize the ecu when it did before all this started going wonky.
Logged
1gcrazy
Full Member
***

Karma: +0/-3
Offline Offline

Posts: 99


« Reply #4 on: May 15, 2020, 02:07:37 PM »

Just got it working *facepalm
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 16 queries. (Pretty URLs adds 0.001s, 0q)