Hello! Im trying to read out my ECM in my 1999 Audi S4 B5, i belive that the car already has a stage 1 tune.
No luck yet! Using a ebay cable i had laying around since before labeled K+Dcan USB Interface (INPA compatible)
VCDS works can read&clear errorcodes no problem.
Nefmoto can connect with car and i can get the info about the ECU.
Always ends up with
Disconnecting because no response was recieved for the tester present messageAnyone dealt with this problem before? Is my cable the problem? I think it is weird that it connects and starts a reading then stops because the message above..
If the cable was bad then it shouldnt be able to connect at all?
Thinking about buying a kess v2 master clone if i don't get nefmoto to work, anyone had luck with kess?
Will post some dumps here:
