Hi,
I am working on a 35 old BMW instrument cluster that has an EPROM that controls RPM speed.
The dump is only 64 bit listed below,

B0 15 00 00 A0 56 1A 7B

It will not work if I change any bit. So, there is checksum in it.

I tried many methods (Checksum, Checksum xor, checksum Mod, checksum 2s complement, LRC, CRC, ) to figure out what checksum algorithm was applied but no success.
I appreciate any insight and expertise that you can provide.
Thank you,
Ad

Appreciate your reply.
I do not know for sure. I have no information or datasheet about this eprom. I built an emulator that uses to the same code to make the cluster to work as it should.
However, once I change any bit in the code the cluster stop working. Therefore, I assumed that there is CS somewhere in this eprom code.