Pages: [1]
Author Topic: how can i find out what the offset is?  (Read 4865 times)
xxx8indxxx
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 115


« on: May 01, 2012, 11:12:05 AM »

ok i have a m3.8.3 map pack and it says to disable my o2 heaters i need to zero out 07CD1 AND 07CD0 BUT I ACTUALLY NEEDED TO ZERO OUT 077C4 AND 077C5 HOW CAN I FIND THE OFFSET TO TRY TO LINE UP THE REST OF MY ADDRESSES? IS IT POSSIBLE TO FIGURE OUT?
Logged
xxx8indxxx
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 115


« Reply #1 on: May 01, 2012, 11:19:03 AM »

would the offset be 50c ?
Logged
ricekikr
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 104


« Reply #2 on: May 01, 2012, 08:44:04 PM »

I don't think there's a universal offset for the whole map. Each address has a different offset. But maps that are close to each other sometimes have the same offset.
Logged
rob.mwpropane
Sr. Member
****

Karma: +32/-0
Offline Offline

Posts: 370


WWW
« Reply #3 on: May 02, 2012, 04:03:28 AM »

would the offset be 50c ?

Can I ask what you use to search for maps/locations? I don't think your going to find one offset makes everything line up. I have limited experience with ME5.9.2 and prior, but you'll have to manually line things up and define them, and then the next and so on.
Logged

This has nothing to do with cars but you can see my glorifying job at,

www.MWPropane.com
bckslyr2003
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 7


« Reply #4 on: May 02, 2012, 04:08:15 AM »

I used a damos 3.8 file  and offset it by 50c and it aligned the loaction for my o2 heaters perf#ctly
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.019 seconds with 16 queries. (Pretty URLs adds 0s, 0q)