Pages: [1]
Author Topic: Difference between CAN bus for RNS-D and RNS-E  (Read 5470 times)
BlackT
Hero Member
*****

Karma: +79/-39
Offline Offline

Posts: 1415



« on: March 26, 2021, 11:16:48 AM »

What is difference between CAN-BUS communication for RNS-D, and RND-E
RNS D use TMC tuner to convert CAN-BUS signal from cluster to RNS-D.  In elsa that signal is labeled as CAN-BUS(BOSCH)



RNS-E is connected directly to navigation CAN-BUS in cluster
Logged
BlackT
Hero Member
*****

Karma: +79/-39
Offline Offline

Posts: 1415



« Reply #1 on: March 28, 2021, 03:34:49 AM »

I checked with osciloscope signal before(RNS-D send) and after TMC tuner.(schould be same signal that RNS-E use)
Far as I can see these are both 100 kbs, and ISO 11898-3
Logged
Stoti
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 79


« Reply #2 on: June 27, 2021, 01:09:28 AM »

I have juat pullged in mine in gray connector pin 5 and 6 i think and everything works , Power on,off illumination and navigation information. I was doing emulator and i think it was 500 kbps but i cant remember i have to check
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 18 queries. (Pretty URLs adds 0s, 0q)