Pages: [1]
Author Topic: ME7.2 BMW V8 Hardcoded Limits in iDA Disassembly  (Read 3158 times)
Fabioo
Full Member
***

Karma: +0/-2
Offline Offline

Posts: 51


« on: June 16, 2021, 01:04:59 PM »

Hello, if anyone could help me find Hard caps because my ignition is getting cropped out after i exceed 800kg/h maf, at 1000kg/h (70% load) i got around -10 retarded (armd/msr/asr disabled). The car is 0.5Bar Boosted Smiley MAF Limits increased etc. etc.
I think its about Cylinder Air Filling (rl_w)

Ida Version: 6.8.150423 (32bit)

i have found 10AAh but after i change it i can't do Adaptations anymore and i still have Hard Caps.

---FIXED---
ARMD wasn't fully disabled.
« Last Edit: June 21, 2021, 10:54:25 AM by Fabioo » Logged
prj
Hero Member
*****

Karma: +1072/-481
Offline Offline

Posts: 6037


« Reply #1 on: June 17, 2021, 01:01:16 AM »

You are searching for something that does not exist.
Your problem is bad calibration or mechanical problems.
Logged

PM's will not be answered, so don't even try.
Log your car properly - WinOLS database - Tools/patches
sda2
Full Member
***

Karma: +23/-1
Offline Offline

Posts: 76


« Reply #2 on: June 17, 2021, 02:47:47 AM »

Like I said, you have to check the raw maf voltage and see if that rises after 1088kg/h. If it does, its in the software, if it doesnt, its maxed out or input circuitry has other limitations.

The usual 100% load limit like in ME7.1 VR6 NA is not present in BMW code for ME7.2.  (compare again 0x10AA stuff)
Logged
Fabioo
Full Member
***

Karma: +0/-2
Offline Offline

Posts: 51


« Reply #3 on: June 21, 2021, 10:55:18 AM »

Thanks for reply guys but it wasn't MAF as i said i've had 1080KG/h which was 3.7V in MAF Table. The point was ARMD wasn't fully disabled.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.012 seconds with 15 queries. (Pretty URLs adds 0s, 0q)