Pages: [1]
Author Topic: Hello from New York  (Read 1803 times)
Parallax9
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 7


« on: August 02, 2021, 04:35:32 PM »

Glad I stumbled across this place, seems to be loads of useful members and information around!

I own 4 B5/5.5s, so most of my interest will be around these vehicles. Currently having issues with my 2003 Wagon, with can data bus single wire mode errors, as well as being unable to read the eeprom from the ecu or dash using commander or eeprom programmer. No ECU found, RX and TX Timeouts, no resolutions. Vcds works fine and communicates with all modules, but I cannot get any of the  eeprom related programs to read without errors.

I've tested the ch340 cable etc on another vehicle of mine, and was successful in pulling the ECU dump to retrieve SKC.


Looking forward to some learning through interaction, and hopefully getting these issues resolved so I can move into more rewarding territory.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.011 seconds with 16 queries. (Pretty URLs adds 0s, 0q)