Pages: [1]
Author Topic: P0140  (Read 527 times)
totti
Full Member
***

Karma: +12/-24
Offline Offline

Posts: 223


« on: October 07, 2021, 11:18:27 AM »

Hi,

I've installed a 100cell cat and I could not insert the 2nd lamda sensor. I've disconnect it and switched off ESKONF.
LSHHK to 11
CDKAT to 0
CDLASH to 0

But I've the error code sometimes after a long run. What to do?

Thank you
Logged
Blazius
Hero Member
*****

Karma: +60/-30
Offline Offline

Posts: 1058



« Reply #1 on: October 07, 2021, 05:06:22 PM »

Code it out properly, s4wiki covers this, eskonf and those 3 are not enough.
Logged
totti
Full Member
***

Karma: +12/-24
Offline Offline

Posts: 223


« Reply #2 on: October 09, 2021, 02:23:46 AM »

Code it out properly, s4wiki covers this, eskonf and those 3 are not enough.

that is written in s4wiki: If you intend to disconnect/remove the sensors, the first thing to try is to configure ESKONF (13 bytes starting at 0x10C75):[58]. As a side benefit, even if you still intend to leave the sensors installed and connected, you should not need to disable circuit diagnosis.
The rear o2 sensor section a little bit confuse me. There are several subsections to switch it off.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.012 seconds with 17 queries. (Pretty URLs adds 0s, 0q)