Pages: 1 [2]
Author Topic: Me7.1.1 No longer communicating  (Read 5418 times)
markhodges78
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 32


« Reply #15 on: January 12, 2022, 11:32:13 AM »

More inclined to think your set up is not working correctly.  Did you try rebooting your pc and check device manager for correct port? And check settings?  Check your connections again ?  Do you have a digital power supply is there any current being drawn when you power up? Check Kline wires?  If you put your obd reader back in the car I’m sure you can check address 2 tranny or some other module.

Ok checked the com port that was correct.. The cable is recognized in vcds and nefmoto when I power on the ecu the ecu and cable are pulling 0.245 amps so im thinking dead.. and the more I think there's no way I reversed the power because its all soldered and it worked over a dozen times...
« Last Edit: January 12, 2022, 11:54:59 AM by markhodges78 » Logged
markhodges78
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 32


« Reply #16 on: January 12, 2022, 11:54:16 AM »

Here is the log file
Logged
Geomeo
Full Member
***

Karma: +10/-6
Offline Offline

Posts: 146


« Reply #17 on: January 12, 2022, 03:12:00 PM »

Here is the log file
Did you try going through all the different baudrates?
Logged
markhodges78
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 32


« Reply #18 on: January 12, 2022, 07:14:42 PM »

I'm pretty sure it's done I have a chip on the right side of the board heating up pretty good...
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 17 queries. (Pretty URLs adds 0s, 0q)