Pages: [1]
Author Topic: Need damos for ME7.5.5 0261207754 1037363476 8E0909557E (Audi A4 B6 2.0 ALT)  (Read 2961 times)
EcuMan
Newbie
*

Karma: +0/-1
Offline Offline

Posts: 6



Hello guys,

I try to create Pops & Bangs for my Audi A4 B6 2.0 ALT (automatic gearbox) with A/C on but I'm not able to find the right DNWEK value. I found one with the stock value 80 rpm and changed it to 8000 rpm but  it's not working. CWSAWE, KFTVSA and KFNWEGM would be also nice. Maybe someone can help me out?

Thank you very much!
« Last Edit: March 30, 2022, 04:43:39 AM by EcuMan » Logged
TFRAG
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4



Hi, I did it on my car, but through other cards, if interested, I can share my experience.
Logged
adam-
Hero Member
*****

Karma: +122/-33
Offline Offline

Posts: 2177



Hi, I did it on my car, but through other cards, if interested, I can share my experience.

You'd have been quicker 'sharing your experience' than typing that.
Logged
TFRAG
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4



Here are all the addresses that need to be changed
CWSAWE - $ 11969 (возможно, должны быть протестированы nulls рядом с этим адресом)
KFZWMN - $ 125F1
KFTVSA - $ 198A7
KFTVSAKAT - $ 198CF
CWSAWE you need to change the value of 0 to 1
KFZWMN minimum ignition after 3000ob/min the last two lines at low loads are -19.5 and the third from above is -9.75 for a smooth transition
KFTVSA delay time 1.5sec after 3000ob/min
on the second KFTVSAKAT card as well, only here in ms
Here is my firmware, the machines are the same, there are already all the changes, but I'm not sure about CWSAWE

But it seems to have too big angles
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 17 queries. (Pretty URLs adds 0s, 0q)