Pages: [1]
Author Topic: Me7 conversion no rev counter in Vw T25/Vanagon  (Read 10405 times)
jims13
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« on: May 02, 2022, 04:04:07 AM »

Hi,

so i am running a AEB engine with APU loom, in a Vw T25 or Vanagon (as some may know it)
the APU loom has had the wires added for wideband.
Engine runs great, however having issues getting a rpm signal.

fairly sure pin 37 from the ecu supplies this.
 When i ran the AEB loom , i used a small box to convert the signal to use with my clocks.
worked great for the time that loom was fitted.
currently wired the same pin into the box, but nothing.

is this because of the way the signal is delivered, i.e digital rather than analog as the clocks expect to see.
any easy eay of changing this ?
i've seen that it may be possible to recode in the ecu ??

thx
Logged
InlandViking
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 21


« Reply #1 on: August 04, 2022, 12:33:27 PM »

If you haven't figured this out yet, it is a signal issue.   MSD makes a signal converter..
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.012 seconds with 16 queries. (Pretty URLs adds 0s, 0q)