Pages: [1]
Author Topic: Problem with rev limit on 8E0518AL with 5120 hack  (Read 1545 times)
BlackT
Hero Member
*****

Karma: +79/-40
Offline Offline

Posts: 1425



« on: August 11, 2022, 10:45:04 PM »

Code:
Reading Version Strings...
-> Bootrom Version = 06.02
-> EPK = 40/1/ME7.5/5/A505U//24I4/24I4AL2/171106/
-> Contents of ECUID data table:
   - '0261208228'         (SSECUHN)        
   - '1037386802'         (SSECUSN)        
   - '8E0909518AL '       (VAG part number)
   - '0005'               (VAG sw number)  
   - '1.8L R4/5VT    '    (engine id)      
-> Contents of ECUID data table:
   - 'HW_MAN004'      
   

File have 5120 hack, car is driving without problems except rev limiter. Even I set all limiters I found at 7300 my throttle plate is closing at 6900 to 50% ( it is not load reduction)
Also there is no hard limit at 7200

Can someone spot what am I missing? Hard limiter is no problem in this case, I can make it with ASM
Curent car is on Alpha-n , I did not sort SD till end yet
 
« Last Edit: August 11, 2022, 10:47:31 PM by BlackT » Logged
fknbrkn
Hero Member
*****

Karma: +186/-24
Offline Offline

Posts: 1455


mk4 1.8T AUM


« Reply #1 on: August 12, 2022, 12:27:04 AM »

Tsrldyn always follows tsmax when e_lm active
Duno about tb, could be ps_w issue (wdkugdn and so on)
Logged
gremlin
Hero Member
*****

Karma: +196/-9
Offline Offline

Posts: 654


« Reply #2 on: August 12, 2022, 10:50:20 PM »

Even I set all limiters I found at 7300 my throttle plate is closing at 6900 to 50% ( it is not load reduction)

Check what fra_w, frao_w and rkat_w shows at the moment before throttle will be 50% closed.
« Last Edit: August 12, 2022, 11:26:58 PM by gremlin » Logged
BlackT
Hero Member
*****

Karma: +79/-40
Offline Offline

Posts: 1425



« Reply #3 on: August 16, 2022, 07:19:09 AM »

Thank you very much, I will report after solving problem
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 17 queries. (Pretty URLs adds 0s, 0q)