Pages: [1]
Author Topic: Flashing Cable Question  (Read 1281 times)
Gus
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« on: September 17, 2022, 09:32:46 AM »

I built a flashing cable using the info in the getting started post. My question is about the CAN line. I am trying to connect to a 2004 Audi Allroad TIP ECM ME7.1.1 (47Z 907 551 R.) I have been successful connecting to a ME7.5 (4B0 906 018 CM). My flashing cable is not wired for CAN communication. Is that why I cannot connect to the ME7.1.1 ECM?
Logged
Gus
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« Reply #1 on: September 17, 2022, 10:20:21 AM »

Attached screenshot of failure
Logged
Gus
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« Reply #2 on: September 19, 2022, 03:19:57 PM »

Added battery 12V+ to  pin 21 and I can see the module now. Off to figure out flashing.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.011 seconds with 16 queries. (Pretty URLs adds 0s, 0q)