ECM is from a 2004 Audi Allroad 2.7. ME7.1.1
I tried grounding pin 24 for a few seconds while powering up bench cable. Using Argdubs command line tool I get this:
C:\me7>me7eeprom --bootmode 95P08 -b 9600 -r -p 3 allroad.bin
ME7_EEPROM v1.40
COM: 3, Baud Rate: 9600
Memory type: 95P08, size: 1024
Opening COM3 ... OK
Starting Boot_mode ... FAIL ... No ECU response. (error=0x20F07)
Closing COM3
I cycle the power to ecm and can connect and check faults. I also get a similar error in --obd mode not grounding pin 24. I have tried all the baudrates listed too. What am I doing wrong?
The program doesn't like Windows 11 Not sure about 10 or 7. But XP worked for me. Make sure you're grounding the correct pin and not wiring it just to the track /solder next to it. grounding = 0v on your power supply.
