Pages: [1]
Author Topic: MED17.5.2Launch Control  (Read 9792 times)
yangbohan
Newbie
*

Karma: +0/-2
Offline Offline

Posts: 16


« on: November 30, 2022, 09:16:14 PM »

MED17.5.2 Can launch control be performed? I need it, but it cannot be started after changing with LC software. Please tell me the price! Thanks!
Logged
_nameless
Hero Member
*****

Karma: +319/-444
Offline Offline

Posts: 2648



« Reply #1 on: December 01, 2022, 09:58:17 AM »

Odds are your tools are not doing a full write. Most likely only calibration. Take file with code and write it to the ecu and then read it back out. If it doesn't match bit for bit, then your tool is not doing a full write. If you are using ktaf that's your problem. Factory support says " don't modify outside calibration and you won't have a problem". So they are not going to fix it. Other tools will do full flash.
Logged

If you are in the market for a tune and would like the ease of downloading and flashing a dyno tested tune for a fair price check out https://instatune.sellfy.store/
yangbohan
Newbie
*

Karma: +0/-2
Offline Offline

Posts: 16


« Reply #2 on: December 02, 2022, 12:39:39 AM »

Thanks! I use Dimsort for reading and writing and I see on the LC software official website that this ECU is not well supported
Logged
_nameless
Hero Member
*****

Karma: +319/-444
Offline Offline

Posts: 2648



« Reply #3 on: December 02, 2022, 04:07:15 AM »

Thanks! I use Dimsort for reading and writing and I see on the LC software official website that this ECU is not well supported
If it patched the file it will work as long as your tool writes the file back correctly. I suspect it is not. Do as I said above to test
Logged

If you are in the market for a tune and would like the ease of downloading and flashing a dyno tested tune for a fair price check out https://instatune.sellfy.store/
yangbohan
Newbie
*

Karma: +0/-2
Offline Offline

Posts: 16


« Reply #4 on: December 05, 2022, 09:35:14 PM »

Thank you for your advice! I will try again
Logged
neuro
Full Member
***

Karma: +24/-9
Offline Offline

Posts: 73


WWW
« Reply #5 on: January 09, 2023, 02:51:12 PM »

launch control can be performed with launch17 software at www.neurosuite.ca (delete if not permitted).
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.015 seconds with 17 queries. (Pretty URLs adds 0s, 0q)