Pages: [1]
Author Topic: KFZW my ignition angle is too low  (Read 995 times)
bombis
Jr. Member
**

Karma: +0/-2
Offline Offline

Posts: 31


« on: August 12, 2024, 07:48:38 AM »

I want to run 11 degree timing, my KFZW values. Why am i only getting 6 degree?
« Last Edit: September 09, 2024, 12:57:29 PM by bombis » Logged
bombis
Jr. Member
**

Karma: +0/-2
Offline Offline

Posts: 31


« Reply #1 on: August 22, 2024, 01:49:41 PM »

Runs stronger now. Around 9 deg timing at 5000rpm+ WOT
Adjusted kfmizuof and kfmizufil to 100. Disconnected MAF sensor.
« Last Edit: September 30, 2024, 02:52:35 AM by bombis » Logged
bombis
Jr. Member
**

Karma: +0/-2
Offline Offline

Posts: 31


« Reply #2 on: September 09, 2024, 12:15:04 PM »

Timing was fine when i disconnected maf sensor.
I want to run with MAF,(because of ESP light etc) but now timing is unsable, why?
« Last Edit: September 09, 2024, 12:17:19 PM by bombis » Logged
Audirama
Jr. Member
**

Karma: +3/-1
Offline Offline

Posts: 30


« Reply #3 on: September 10, 2024, 04:35:45 PM »

I am wondering about this too,

I am running on e85 blend e60 with no knock and still getting less timing than KFZW, i will get 20-21 degrees when targeting 23-24, I've been trying to isolate what else influences the actual ignition timing
Logged
bombis
Jr. Member
**

Karma: +0/-2
Offline Offline

Posts: 31


« Reply #4 on: October 06, 2024, 12:34:28 PM »

1. kfmdadp, kfmdaro, kfmdaros increase works best Smiley (thanks to gremlin for map locations)
2. I think FF Kfmizouf/kfmizufil works, but Wiki says wrong way.
3. TMAR increase might work, according to the forum
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 17 queries. (Pretty URLs adds 0s, 0q)