Pages: [1]
Author Topic: Tuner Pro  (Read 3993 times)
belligerent_b5
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« on: July 30, 2012, 09:50:28 PM »

Ok, so I'm building an .xdf for the CH box based on rob.mwpropane's map pack for s/w ver. 360101. Most of the tables I can transfer over just fine, but one will not display correctly in Tuner Pro. I have the correct offset, address, cell size and axes for this table (taken from the WinOLS map properties), but Tuner Pro is not calculating the values correctly. Even switching the order of the bits is not helping... they're both wrong.

I'm wondering if Tuner Pro does not adjust the bit order properly, as I've noticed that on some of my other maps/axes that the bit order I have to select to make it display properly is opposite of what WinOLS says it is.

Any insight into my problem?
Logged
littco
Hero Member
*****

Karma: +52/-7
Offline Offline

Posts: 903


« Reply #1 on: July 31, 2012, 06:31:11 AM »

post your xdf and flash and which map is the issue
Logged
belligerent_b5
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« Reply #2 on: July 31, 2012, 10:25:17 AM »

Nevermind, I figured it out  Grin Guess I shouldn't do this very late at night.
Logged
userpike
Hero Member
*****

Karma: +22/-1
Offline Offline

Posts: 763


« Reply #3 on: July 31, 2012, 11:40:45 PM »

Nevermind, I figured it out  Grin Guess I shouldn't do this very late at night.
So what was the solution?
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 16 queries. (Pretty URLs adds 0.001s, 0q)