Hello everyone,
Let's see if someone gives me a hand and tells me that it may be happening that my MPPSv18 is not able to read the Bosch ME7.0 ECU (0261204559 26SA5329) of my Volvo C70 T5 1999. It has Flashmemory 512kb AM29F400AB. I Apply bench mode and bootmode with pin-out corresponding. I boot with pin 24 to ground. The connections I apply are those in the photos, although to say that the one that indicates that there is ignition is not real because that pin is the camshaft sensor pin.
Anyway, I've tried both ways and the message I get is always the same "Error Booting ECU". On the other hand, I know that boot mode is activated because the mAh consumption is not the same with or without active boot: without boot mode 300mah and with boot it goes down to 268mah, both are always constant.
The connections are simple but I'm afraid that something Volvo is entering the game and won't even let me do the ID, read or write. I use Windows 10 64-bit.
Any idea what may be going on?
Thank you so much, any help will be welcome.

Ty man, I think MPPSv18 is not capable to connect to it. I will buy KTAG as all videos I find use it. However, Mppsv18 is also used with Bosch ME Ecus, but i think that here the problem is the combination between Bosch ME and Volvo. This last one is more suspicious that other brands.