trichard3000
Full Member
Karma: +6/-1
 Offline
Posts: 57
|
 |
« on: August 07, 2012, 08:34:09 PM »
|
|
|
I’m trying to make sure that I can access boot-mode flashing if necessary. Most of the issues that people report with this cable/software is that they can’t get past the “Boot Mode Inactive” error.
In my case, I can get past that but then things get goofy. Sometimes I can read the ECU info and sometimes it just errors out. If I try to write an image, again sometimes it errors out right away, other times I get a scrolling status bar. I’ve never gotten it to put a whole flash on the box, though.
Any pointers on this kind of intermittent behavior?
|
|
|
|
|
Logged
|
|
