Pages: [1]
Author Topic: m5.9.2 engine won't start after flashing  (Read 4244 times)
00gtw00
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 6


« on: August 14, 2012, 12:42:54 AM »

ECU is M5.9.2 06A 906 018 GM ( 0 261 206 921 )
VW Golf 2.0 AQY

After flashing engine won't start and vcds can't connect to ecu.
MPPS see ecu and can flashing. I flashing ecu using ORI file but result is the same. I desolder flash and check content - is correct. I get ecu form car. On bench connected 1,3,43 pin to +12V, 2 pin to GND, 19 pin to k-line. Flashing process was finishing with no problems. Is some to do after flashing?
Logged
@lq!
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 62


« Reply #1 on: August 14, 2012, 02:02:21 AM »

i think you can need a new chip. it may be damaged.
Logged
pvl
Sr. Member
****

Karma: +32/-1
Offline Offline

Posts: 350


« Reply #2 on: August 14, 2012, 02:34:47 AM »

I think with the given solution i gave him, the ecu can be ressurected Wink

Different ending letters, but that doesn't matter for this ecu. Same hardware-design for same engine.

Cheers,

PvL
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 16 queries. (Pretty URLs adds 0s, 0q)