Hi

I have tried adjust Pid values for my tune to get max. boost level at 1,35bar but no luck so far. Every wot run at third gear i get spike boost 1,5bar. Can somebody help to deside what to adjust and how much. KFLDIMX ?

I need to get boost lower because i think that 1,5bar is too much for my current turbo K03-073. Also my part protection EGT readings are quite hi i think.

Car is Audi A4 B5 1.8T AWT avant quattro. Mods: B6 BEX turbo (k03-073)+exhaust manifold and 0280156061 317cc/min 3bar injectors.

 

So i must have understand wrong some basic stuff. I have assume that LDRXN would define requested boost. My tune request 1,3bar but actual will go way over it.

No mechanical issues: New dv and n75, pressure test->OK, wastegate tested->ok.

Overshoots only in long WOT pulls when starting under 2000rpm.
I have tried lower KFLDIMX but then boost stay too low when WOT at 3000rpms.
I have tried raise KFLDRQ2 but then boost start oscillate between 0,3-0,7 at steady state conditions (going uphill, steady load).

How i should mod KFLDRL? Now its 95% at 95% every rpm sector on it.