Pages: [1]
Author Topic: Calculate exactly KRKTE for this software  (Read 7559 times)
Dobermann
Full Member
***

Karma: +7/-0
Offline Offline

Posts: 80


« on: September 28, 2012, 12:48:03 PM »

hello folks

i need help to calculate for this software KRKTE

its a seat leon cupra R 1.8 T 225 HP

stock injectors are 380cm Bosch and new are 440 green Bosch

here is the file please help to calculate im not sure if my calculation are right !!

KRKTE is at this adress >> 01CD82



Logged
Gonzo
Sr. Member
****

Karma: +21/-30
Offline Offline

Posts: 483


« Reply #1 on: September 28, 2012, 01:35:15 PM »

http://nefariousmotorsports.com/forum/index.php?topic=2625.0
Logged
Dobermann
Full Member
***

Karma: +7/-0
Offline Offline

Posts: 80


« Reply #2 on: September 29, 2012, 01:13:34 PM »


thanks for the link i found that too but i tryed with this !! in my case the calulation is not right !! the car run always to rich !!

please have  a look and try to calculate !!

thanks and best regards
Logged
Gonzo
Sr. Member
****

Karma: +21/-30
Offline Offline

Posts: 483


« Reply #3 on: September 30, 2012, 07:03:52 AM »

You need to look at your fuel trim and adjust KRKTE based in your fuel trim. Its not going to be perfect out of the box.
Logged
RaraK
Hero Member
*****

Karma: +58/-2
Offline Offline

Posts: 539


« Reply #4 on: September 30, 2012, 09:45:27 AM »

2nd value of block 32 will get krkte close, tvub can be fine tuned by block 32 1st value

then work on fine adjustments through cruise in the fkkvs table.  log the injection time and correction and then make % adjustments to fkkvs. 
Logged
Bische
Sr. Member
****

Karma: +25/-4
Offline Offline

Posts: 397



WWW
« Reply #5 on: September 30, 2012, 10:39:30 AM »

Does anyone tune acceleration enrichment and wall wetting when calibrating injectors?

Or are those left stock?
Logged
Dobermann
Full Member
***

Karma: +7/-0
Offline Offline

Posts: 80


« Reply #6 on: October 01, 2012, 12:51:12 PM »

2nd value of block 32 will get krkte close, tvub can be fine tuned by block 32 1st value

then work on fine adjustments through cruise in the fkkvs table.  log the injection time and correction and then make % adjustments to fkkvs. 

i tested this today !! block 32 value 2 is 0 % and first too in idle

lambda is near 1 in block 31

the values are ok with my KRKTE but car runs always to rich !! and the idle is bad !! sometimes happens missfire on zylinder 3 and 4

but its clear the car get to many fuel with this injectors ! with stock injectors 380 ccm all is ok !!

i use this one Bosch Green (0280150558)

for the moment i dont know what to do !!

i hope someone can help !!
Logged
Rick
Hero Member
*****

Karma: +63/-4
Offline Offline

Posts: 704


« Reply #7 on: October 01, 2012, 02:23:55 PM »

If block 032 is 0 then something is preventing adaptation.  Post logs of block 001, 031 and 032 with lots of idling and light cruise.

Rick
Logged
nokiafix
Full Member
***

Karma: +19/-2
Offline Offline

Posts: 124


« Reply #8 on: October 02, 2012, 02:39:58 PM »

What is you lambda reading on idle?
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.035 seconds with 16 queries. (Pretty URLs adds 0.001s, 0q)