|
jibberjive
|
 |
« Reply #15 on: April 06, 2011, 05:55:38 AM »
|
|
|
I'll be running 1000cc'ers as well. Likely eventually at 6bar on E85 ha, after I dial in a 91 oct tune.
|
|
|
|
|
Logged
|
|
|
|
|
judeisnotobscure
|
|
« Reply #16 on: April 11, 2011, 07:14:26 PM »
|
|
|
I plugged the data from the spec sheet into excel. here is the formula for voltage vs. correctin factor @ 4bar. below 10 volts it apears to be linear. so this only aplies above 10 volts. 1.2634 is the correction factor from 2.66 bar to 4 bar. Y= voltage X= correction factor (ms) @4bar Y= -6.596* ln(X)+ 14.012 here are the values i got @ 4bar with 0280158117 from the spec sheet http://www.boschdealer.com/specsheets/0280158117cs.jpg |
|
|
|
« Last Edit: April 11, 2011, 07:18:25 PM by judeisnotobscure »
|
Logged
|
I have a b5 s4
but i just want to dance.
|
|
|
NOTORIOUS VR
Administrator
Hero Member
Karma: +58/-7
 Offline
Posts: 1056
|
|
« Reply #17 on: May 13, 2011, 05:58:22 AM »
|
|
|
I'm gonna install my ID1000's today with my 85mm MAF, thinking about using Tony's base file... Anyone wanna give me a hand for KRKTE and TVUB? I will be installing with the stock 4 BAR FPR.  |
|
|
|
|
Logged
|
|
|
|
Tony@NefMoto
Administrator
Hero Member
Karma: +132/-4
Offline
Posts: 1389
2001.5 Audi S4 Stage 3
|
|
« Reply #18 on: May 16, 2011, 12:06:53 PM »
|
|
|
I'm gonna install my ID1000's today with my 85mm MAF, thinking about using Tony's base file...
Anyone wanna give me a hand for KRKTE and TVUB?
I simply changed TVUB based on LTFT for idle, and KRKTE based on on LTFT for partial load. Rinse and repeat. |
|
|
|
|
Logged
|
|
|
|
NOTORIOUS VR
Administrator
Hero Member
Karma: +58/-7
Offline
Posts: 1056
|
|
« Reply #19 on: May 16, 2011, 12:16:48 PM »
|
|
|
I simply changed TVUB based on LTFT for idle, and KRKTE based on on LTFT for partial load. Rinse and repeat.
So basically, if it was too lean/correction @ idle you adjust the TVUB to give more fuel? |
|
|
|
|
Logged
|
|
|
|
|
julex
|
|
« Reply #20 on: May 16, 2011, 12:33:18 PM »
|
|
|
I simply changed TVUB based on LTFT for idle, and KRKTE based on on LTFT for partial load. Rinse and repeat.
So basically, if it was too lean/correction @ idle you adjust the TVUB to give more fuel? Yes, TVUB has large influence in short duration injector pulse while the longer the injector stays open the less influence it has % wise. Say 0.8ms TVUB at idle is probably about 50% (assuming 1.6ms per pulse at idle) while 0.8ms at WOT with 15ms pulse is only about 5%. Adjusting TVUB has 10 fold higher influence at idle than at WOT in such situation. |
|
|
|
|
Logged
|
|
|
|
Matt Danger
Full Member
Karma: +17/-1
Offline
Posts: 116
|
|
« Reply #21 on: May 16, 2011, 05:10:28 PM »
|
|
|
I'm gonna install my ID1000's today with my 85mm MAF, thinking about using Tony's base file...
Anyone wanna give me a hand for KRKTE and TVUB?
I simply changed TVUB based on LTFT for idle, and KRKTE based on on LTFT for partial load. Rinse and repeat. What did you configure for WOT fueling? KRKTE? |
|
|
|
|
Logged
|
|
|
|
NOTORIOUS VR
Administrator
Hero Member
Karma: +58/-7
Offline
Posts: 1056
|
|
« Reply #22 on: May 16, 2011, 07:00:37 PM »
|
|
|
What did you configure for WOT fueling? KRKTE?
Correct.... BTW, I did what you suggested nyet and played with TVUB and the idle and cruise is considerably better now. Thanks again! Need to get my wideband in. |
|
|
|
|
Logged
|
|
|
|
|
s5fourdoor
|
|
« Reply #23 on: June 07, 2011, 04:15:59 PM »
|
|
|
After more research on this, I believe TVUB could be kept stock with the Bosch EV14 series of injectors. Can anyone confirm this?
|
|
|
|
|
Logged
|
|
|
|
NOTORIOUS VR
Administrator
Hero Member
Karma: +58/-7
Offline
Posts: 1056
|
|
« Reply #24 on: June 07, 2011, 05:49:47 PM »
|
|
|
After more research on this, I believe TVUB could be kept stock with the Bosch EV14 series of injectors. Can anyone confirm this?
That didn't work at all for me |
|
|
|
|
Logged
|
|
|
|
|
s5fourdoor
|
|
« Reply #25 on: June 08, 2011, 08:44:51 AM »
|
|
|
Hmm. You are using ID1000's, right? I'm using EV14 550cc. So far not having any problems with stock TVUB values, which isn't too shocking because Bosch makes both injectors. I need to figure out how to diagnose whether the injectors need that table changed or not...
|
|
|
|
|
Logged
|
|
|
|
|
julex
|
|
« Reply #26 on: June 08, 2011, 09:12:20 AM »
|
|
|
Hmm. You are using ID1000's, right? I'm using EV14 550cc. So far not having any problems with stock TVUB values, which isn't too shocking because Bosch makes both injectors. I need to figure out how to diagnose whether the injectors need that table changed or not...
IF the car behaves well, no idle fluctuations/stalling, no strange deviations in block 032 and WOT is right on.... leave it as is. |
|
|
|
|
Logged
|
|
|
|
NOTORIOUS VR
Administrator
Hero Member
Karma: +58/-7
Offline
Posts: 1056
|
|
« Reply #27 on: June 08, 2011, 11:15:43 AM »
|
|
|
Hmm. You are using ID1000's, right? I'm using EV14 550cc. So far not having any problems with stock TVUB values, which isn't too shocking because Bosch makes both injectors. I need to figure out how to diagnose whether the injectors need that table changed or not...
Yes I'm running ID1000's, with stock TVUB values the car is so lean it almost doesn't run. |
|
|
|
|
Logged
|
|
|
|
wickster
Jr. Member
Karma: +2/-0
Offline
Posts: 26
|
|
« Reply #28 on: June 08, 2011, 05:07:11 PM »
|
|
|
Hmm. You are using ID1000's, right? I'm using EV14 550cc. So far not having any problems with stock TVUB values, which isn't too shocking because Bosch makes both injectors. I need to figure out how to diagnose whether the injectors need that table changed or not...
85mm MAF? 4.0 Bar FPR? What KRKTE value are you using and what are your current LTFTs? |
|
|
|
|
Logged
|
'01.5 Audi S4 2.7T - 6MT - K04s - ASP 85mm Hitachi - 49lb Delphi
|
|
|
wickster
Jr. Member
Karma: +2/-0
Offline
Posts: 26
|
|
« Reply #29 on: June 08, 2011, 07:41:33 PM »
|
|
|
Well with a KRKTE of 0.065 and stock TVUB my long term (partial) throttle LTFTs are -21%.
85mm hitachi maf
Bosch EV14 550s @ 4.0 Bar FPR
|
|
|
|
|
Logged
|
'01.5 Audi S4 2.7T - 6MT - K04s - ASP 85mm Hitachi - 49lb Delphi
|
|
|
|
