Pages: [1]
Author Topic: ME7.5 Immo II ecu, pin 21 needed?  (Read 3472 times)
Delta_co
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 7


« on: April 16, 2013, 06:17:23 AM »

I have a 2001 Jetta 1.8T with an 06a 906 032 GH ecu. I am making a bench harness and I see in the bench harness DIY it shows +12v to pin 21 for Immo equipped cars. Is this only Immo 3, or do I need it for Immo 2 also? I don't want to send +12v to somewhere not needed.
Logged
cyril279
Full Member
***

Karma: +12/-2
Offline Offline

Posts: 140


« Reply #1 on: April 16, 2013, 07:16:09 AM »

From my experience thus far, the difference between immo II and III is software, not hardware.
I power pin 21 on my bench harness, and I have flashed and used both immo II and III setups onto the same package.
-Cyril
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.011 seconds with 16 queries. (Pretty URLs adds 0s, 0q)