Bensh flashing ME7.5

Pages: [1]

« previous next »

Author

Topic: Bensh flashing ME7.5 (Read 5135 times)

papasound

Jr. Member

Karma: +1/-1
Offline

Offline

Posts: 29

	Bensh flashing ME7.5 « on: April 26, 2013, 06:47:28 AM »

Hi i have done everything as shown here
http://www.nefariousmotorsports.com/wiki/index.php/ECU_Bench_Flashing
except i put 1k ohm resistor on pin 24, and 5k ohm resistor for touching pin 24 on F800BB,
I just cant find out where is the ignition switch, which pin should be fed with what?


	Logged

Friends will never leave friends on stock.

cyril279

Full Member

Karma: +12/-2
Offline

Offline

Posts: 140

	Re: Bensh flashing ME7.5 « Reply #1 on: April 26, 2013, 08:11:55 AM »

pin 3 is ignition sw.


	Logged

papasound

Jr. Member

Karma: +1/-1
Offline

Offline

Posts: 29

	Re: Bensh flashing ME7.5 « Reply #2 on: April 26, 2013, 10:06:23 AM »

so presumably it should be connected to 12v+ all the time, or after power on and some time after?


	Logged

Friends will never leave friends on stock.

cyril279

Full Member

Karma: +12/-2
Offline

Offline

Posts: 140

	Re: Bensh flashing ME7.5 « Reply #3 on: April 26, 2013, 10:38:49 AM »

many leave it powered all the time along with 62 & 21, I had to install a switch on pin 3 to get mine (me7.1) into bootmode.


	Logged

papasound

Jr. Member

Karma: +1/-1
Offline

Offline

Posts: 29

	Re: Bensh flashing ME7.5 « Reply #4 on: April 27, 2013, 01:16:24 PM »

Thanks for your replies, and i got another question. I unsoldered 5040 and put bin with immo off, do i still need to power pin 21 with 12v+?


	Logged

Friends will never leave friends on stock.

papasound

Jr. Member

Karma: +1/-1
Offline

Offline

Posts: 29

	Re: Bensh flashing ME7.5 « Reply #5 on: April 27, 2013, 07:08:21 PM »

After so many unsuccessful tries i finally got it into boot mode:

Put 2k ohm resistor for pin 21
power on,
ground pin 24 on chip,
ignition on,
after 10 seconds release ground from chip,
try to communicate, fail,
ignition off,
10-20 seconds wait,
ground pin 24 on chip,
ignition on,
after 10 seconds release ground from chip,
try to communicate, success,
power off.

I have Infinion cpu and only that dance saved my day.
Boot mode flashing took about half minute using eobd2Flash cable
with FT232R chip and fresh drivers from http://www.fgtechnology.eu/


« Last Edit: April 27, 2013, 07:11:27 PM by papasound »	Logged

Friends will never leave friends on stock.

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

November 30, 2024, 11:44:07 PM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search