Pages: 1 [2]
Author Topic: R32T dsg tuning  (Read 1172 times)
MOOMO
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 14


« Reply #15 on: October 07, 2018, 09:01:02 PM »

Tried to use that diagram when I had a C brick, and my board was different (despite it being a C box). Made a jig, (guessing at the locations that were different) and no dice.


if this is only the solution I might let the tcu to pass away
Logged
MOOMO
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 14


« Reply #16 on: October 08, 2018, 12:04:34 AM »

Tried to use that diagram when I had a C brick, and my board was different (despite it being a C box). Made a jig, (guessing at the locations that were different) and no dice.

in the end how did you fixed it?
Logged
vwaudiguy
Hero Member
*****

Karma: +47/-35
Offline Offline

Posts: 1968



« Reply #17 on: October 08, 2018, 12:22:15 AM »

I ended up using it as an experiment and getting a replacement.
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
MOOMO
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 14


« Reply #18 on: October 10, 2018, 08:29:41 AM »

Tried using cmd directly on tcu port still not fixed
Logged
teobolo
Full Member
***

Karma: +7/-5
Offline Offline

Posts: 105


« Reply #19 on: October 10, 2018, 11:51:01 PM »

Tried using cmd directly on tcu port still not fixed

if you had time and you can ship to me the mechatronic i will try restore it for free off course , i m located at Athens Greece
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.017 seconds with 18 queries. (Pretty URLs adds 0s, 0q)