DEKA 870cc and bad idle

Pages: [1] 2

« previous next »

Author

Topic: DEKA 870cc and bad idle (Read 15694 times)

envisible

Full Member

Karma: +0/-3
Offline

Offline

Posts: 62

	DEKA 870cc and bad idle « on: September 10, 2013, 11:19:28 PM »

Hi guys.

I try to use 870cc siemens deka injectors on my 2L stroker( AMB based). Fuel system is returnless, stock FPR. Mafless.

ddillenger helps me to locate TEMIN and KRKTE

TEMIN 14DA6 16 BIT FACTOR 0.002667
KRKTE 1F82A 16 BIT FACTOR 0.000167

And I use KRKTE calculator and set it to 0.0363

But now, on cold engine I have very rich mixture and LTFT on idle is about -9.8%. LTFT on partial load is 0.2%.
Injection time on idle is 1.56ms.
Whats wrong with me?

Please don't blame mafless.

Here is flash I use and mappack with just scaling maps.


	Logged

IamwhoIam

Hero Member

Karma: +52/-115
Offline

Offline

Posts: 1070

	Re: DEKA 870cc and bad idle « Reply #1 on: September 11, 2013, 01:59:56 AM »

how do you think your ECU can calculate correctly the amount of fuel that is supposed to be injected under idle/part throttle conditions?


	Logged

I have no logs because I have a boost gauge (makes things easier)

ddillenger

Hero Member

Karma: +641/-21
Offline

Offline

Posts: 5640

	Re: DEKA 870cc and bad idle « Reply #2 on: September 11, 2013, 02:53:32 AM »

Not to mention TVUB

Shocked


	Logged

Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your experience!

Email/Google chat:
DDillenger84(at)gmail(dot)com

Email>PM

Rabbid

Full Member

Karma: +0/-0
Offline

Offline

Posts: 55

	Re: DEKA 870cc and bad idle « Reply #3 on: September 11, 2013, 03:34:15 AM »

Whats your stock FKKVS doing? I've seen some stuff in stock tables add or remove loads of fuel around idle.

But unless your MAFless calibration worked perfectly on stock injectors then you might need to revisit the air mass amounts you're giving it.


	Logged

envisible

Full Member

Karma: +0/-3
Offline

Offline

Posts: 62

	Re: DEKA 870cc and bad idle « Reply #4 on: September 11, 2013, 04:02:57 AM »

Quote from: IamwhoIam on September 11, 2013, 01:59:56 AM

how do you think your ECU can calculate correctly the amount of fuel that is supposed to be injected under idle/part throttle conditions?

By wideband 02 sensor?

TVUB is changed according datasheet http://siemensdeka.com/specsheets/FI114992cs.jpg

Quote from: Rabbid on September 11, 2013, 03:34:15 AM

This injectors never runs with MAF..

Does 1.56ms opening time is OK for this injectors on idle?
I think I need to adjust FKKVS map, but I sorry, I don't understand this map so good.. Could you give me some advice or help to correct it?


	Logged

julex

Hero Member

Karma: +79/-4
Offline

Offline

Posts: 923

	Re: DEKA 870cc and bad idle « Reply #5 on: September 11, 2013, 06:46:38 AM »

Quote from: envisible on September 11, 2013, 04:02:57 AM

By wideband 02 sensor?

TVUB is changed according datasheet http://siemensdeka.com/specsheets/FI114992cs.jpg

This injectors never runs with MAF..

Does 1.56ms opening time is OK for this injectors on idle?
I think I need to adjust FKKVS map, but I sorry, I don't understand this map so good.. Could you give me some advice or help to correct it?

How did you calculate TVUB? let us know exactly since it is most likely calculated wrong... and that sheet has tons of errors. Some values don't make any sense...

Edit: and what's your pulse width at idle, without TVUB added in. Or share what final pulse width is and TVUB values as well as exact voltage at that moment so I can derive. These dekas have a minimum operational pulse width of 0.599ms which is I believe more than what your engine idles as and this would cause near idle problems.


« Last Edit: September 11, 2013, 07:00:38 AM by julex »	Logged

IamwhoIam

Hero Member

Karma: +52/-115
Offline

Offline

Posts: 1070

	Re: DEKA 870cc and bad idle « Reply #6 on: September 11, 2013, 08:11:54 AM »

So a wideband O2 sensor also acts as an air flow sensor? funny that, I would have never thought about something like this.


	Logged

I have no logs because I have a boost gauge (makes things easier)

nyet

Administrator
Hero Member

Karma: +608/-168
Online

Online

Posts: 12271

	Re: DEKA 870cc and bad idle « Reply #7 on: September 11, 2013, 09:26:38 AM »

Quote from: IamwhoIam on September 11, 2013, 08:11:54 AM

So a wideband O2 sensor also acts as an air flow sensor? funny that, I would have never thought about something like this.

That isn't what he's saying Tongue


	Logged

ME7.1 tuning guide
ECUx Plot
ME7Sum checksum
Trim heatmap tool

Please do not ask me for tunes. I'm here to help people make their own.

Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your ex

envisible

Full Member

Karma: +0/-3
Offline

Offline

Posts: 62

	Re: DEKA 870cc and bad idle « Reply #8 on: September 12, 2013, 04:59:29 AM »

TEMIN was found incorrectly
Right adress is 1F824.
And with KRKTE 0.032 it gives me good idle and throttle response on cold engine. LTFT additivi is -2% now.

But I agree, the MAF is necessary. RS4?


	Logged

ddillenger

Hero Member

Karma: +641/-21
Offline

Offline

Posts: 5640

	Re: DEKA 870cc and bad idle « Reply #9 on: September 12, 2013, 11:17:48 AM »

Quote from: envisible on September 12, 2013, 04:59:29 AM

TEMIN was found incorrectly
Right adress is 1F824.
And with KRKTE 0.032 it gives me good idle and throttle response on cold engine. LTFT additivi is -2% now.

But I agree, the MAF is necessary. RS4?

RS4 MAF is good if you intend on exceeding 320g/s. Under that, the S4 bosch is a good choice.


	Logged

hammersword

Full Member

Karma: +31/-2
Offline

Offline

Posts: 136

Revlimit ECU tuning

	Re: DEKA 870cc and bad idle « Reply #10 on: September 12, 2013, 04:20:29 PM »

What are you talking guys? Huh

lambda reads airflow? lol

When the MAF is deactivated you run in secondary load mode = Throttle + MAP! When the engine is in idle the load 100% is calculated via throttle and in software there are many maps for airflow calculation in function of Throttle angle, throttle size, engine displacement!
Installing bigger throttle will kill your airflow calculation if you miss to recalibrate all the Throttle air flow model in the ECU and you will face too lean AFRs and too high positive fueltrims!

I do for many years MAFless setups when the turbo inlet is bigger than 80mm like PTE 6262 or 6765 in 20VTs with injectors ID1000 or ID1200 without having any issue with fueltrims, idle and fueling at all.... Of course for finetuning are needed maaaany files and hours, if you are looking for the perfection which for me is the most important.
KRKTE: I have posted a calculator .xls in NEFMOTO forum
TVUB (easy to be found over the internet for DEKAs and IDs)
FKKVS (The most important and smartest map in Motronics)
TEMIN: 0.5ms is fine for 870cc @ 3bar

cheers,
Fotis


	Logged

www.revlimit.gr
The Motronic Specialists....

silentbob

Full Member

Karma: +30/-1
Offline

Offline

Posts: 141

	Re: DEKA 870cc and bad idle « Reply #11 on: September 18, 2013, 10:13:05 PM »

Quote from: hammersword on September 12, 2013, 04:20:29 PM

......................
FKKVS (The most important and smartest map in Motronics)
......................

Map for fixing shitty calibrations in other areas would be a more precise description for this one.


	Logged

prj

Hero Member

Karma: +1072/-485
Offline

Offline

Posts: 6041

	Re: DEKA 870cc and bad idle « Reply #12 on: September 19, 2013, 03:10:26 AM »

Quote from: hammersword on September 12, 2013, 04:20:29 PM

When the MAF is deactivated you run in secondary load mode = Throttle + MAP!

ME7 does not have MAP.


	Logged

PM's will not be answered, so don't even try.
Log your car properly - WinOLS database - Tools/patches

catbed

Sr. Member

Karma: +8/-2
Offline

Offline

Posts: 300

	Re: DEKA 870cc and bad idle « Reply #13 on: September 19, 2013, 05:25:14 AM »

Quote from: hammersword on September 12, 2013, 04:20:29 PM

What are you talking guys? Huh

Secondary load has nothing to do with MAP sensor. It is alpha-n with o2 feedback.


	Logged

julex

Hero Member

Karma: +79/-4
Offline

Offline

Posts: 923

	Re: DEKA 870cc and bad idle « Reply #14 on: September 19, 2013, 10:19:16 AM »

Quote from: silentbob on September 18, 2013, 10:13:05 PM

Map for fixing shitty calibrations in other areas would be a more precise description for this one.

Amen. Mine is all 1.00 and the car runs great.


	Logged

Pages: [1] 2

« previous next »

Jump to:

Navigation

Personal Tools

November 30, 2024, 04:40:58 PM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search