Pages: [1]
Author Topic: Launch Control  (Read 5110 times)
gigabyte
Full Member
***

Karma: +1/-0
Offline Offline

Posts: 70



« on: October 09, 2013, 04:33:21 PM »

Hey there
I have adjusted the maps for launch control to be implemented in my tune. Before I try it and burn down the road like the bat mobile just want to check some questions in my head.
1- Launch control is always active till you drive faster then the VNMX setting?
2- ITNMXH is for 2 step?
3- TNMXH this only comes into effect if you use launch control? So you will never have to worry about throttle shutting off if you dont use the launch control?
4- Is a decat required or is that just for hard lanch control?
My settings are
VNMX 1.25 kmh
DNMAXH 50 rpm
ITNMXH 0
NMAX 3500 rpm
NMAXOG 7000 rpm
TMOTNMX left at 80.25c
TNMXH 655.3500
Sorry if this is answered before just need to make sure I fully understand it.
Cheers
Logged
krazydbiker
Full Member
***

Karma: +4/-1
Offline Offline

Posts: 202


« Reply #1 on: October 10, 2013, 06:00:48 AM »

just check your nmaxog, its DNMAXH + NMAXOG so your at 7050 rpm for a rev limit.

other then that, looks fine, TNMOTNMX will keep you stuck at a 3500 RPM limit till you exceed that temp, i recommend changing it.

as far as cats, cats do not like popping/unburnt fuel........ you will get a little bit but its not like anti-lag where it will blow your cats right out.
Logged
gigabyte
Full Member
***

Karma: +1/-0
Offline Offline

Posts: 70



« Reply #2 on: October 10, 2013, 06:14:35 AM »

Cheers I kept TMOTNMX as it was didn't want to use it unless engine is warm but I'll take your advice and change it mate. Yeah I heard anti-lag is a killer for cats. I give it a try later have to find a quiet spot somewhere  Grin
Cheers again mate
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 17 queries. (Pretty URLs adds 0.001s, 0q)