added throttle plate.. not sure which parameter acc pdl acceleration is..
you will see initiall full throttle nothing, then me rapid on and off pedal and it starts to work.

wped for pedal? just added and re-linked below


>>log>> http://www.badger-5.com/bin/ttqs_stuff/8n0906018ca-0261208086-1037375111-qs-read_template_20140221_180317.csv

thankyou for reading

Your accell pedal position sensor is broken.

I see wped = 100 and plsol > 2000 mbar and b_ldr = 0

It would be easier to see what's going on with a real pull.

Op, are you just stabbing the pedal in the logs or is pedal position dropping out?

Were you tap dancing on the pedal?

B_ldr looks fine in the area where ped is constant...

I am stabbing the pedal as said, as this for whatever reason brings it to life

yes..  I was. thats why its flapping..
smooth throttle nothing works.. only stabbing the pedal brings it to life..

N75 has been wired direct to ecu also to test, same fault continues.
when the car first came in it has 17705 fault code which I thought was the usual issue, but no codes have ever come up since, no matter what software I have flashed in, on different box, same box, etc.... the fault is constant.

If on real road test, or longer running up and down the box simulating road drive, sometimes, randomly the n75 will come to life.  Its coming to life remains until next ign cycle, and its dead again.

Only if I stab the acc pedal on off tap dancing stylee does it start up working again, pretty much on demand.

I've never ever seen anything behave like this..
If ecu's unhappy, and limp mode type event, no faults logging seems just weird.

Its behaving like the 17705 faultcode would do, but without throwing out that code.(or any for that matter)

Anyone able to think of a potential cause for this weird behaviour?

thanks