Pages: 1 [2]
Author Topic: VW R32 TORQUE LOSS  (Read 11024 times)
Brumbassen
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 18


« Reply #15 on: June 11, 2014, 05:35:09 AM »

The Nefmoto software works great on my R32 i run the CN ecu and have no problem flashing with nef in car
Logged
ported2flow
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 78


« Reply #16 on: June 11, 2014, 04:39:45 PM »

check measureingblock 208/209

is your chain okay?? which values can u read ??

the r32 have an issue with the chains which leads to loss of power....

what fuel do you run check your ignition!!
Logged
G60Dub
Jr. Member
**

Karma: +1/-0
Offline Offline

Posts: 25


« Reply #17 on: June 23, 2014, 11:24:58 AM »

Opps just realised there was a new post - that what I get for setting up rules on my inbox.   Chains are fine at -7 and -9.   There may be an issue with the calibration.  ECU is away for investigation at the moment,
Logged
ported2flow
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 78


« Reply #18 on: June 23, 2014, 02:29:13 PM »

well mate -7 and -9 is time for chain change Wink)) this is not fine .... !!!! i think this is your problem!!!
Logged
G60Dub
Jr. Member
**

Karma: +1/-0
Offline Offline

Posts: 25


« Reply #19 on: June 23, 2014, 02:45:16 PM »

Sorry I meant to write -4 and -7   Embarrassed
Logged
ported2flow
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 78


« Reply #20 on: June 27, 2014, 02:23:43 PM »

not good too... check if its retarding ignition again Wink please report
Logged
G60Dub
Jr. Member
**

Karma: +1/-0
Offline Offline

Posts: 25


« Reply #21 on: June 28, 2014, 10:14:45 AM »

ECU is away at the moment so unable to generate any logs.   Chains will be getting replaced come January along with some Shrick 268s (or sooner if the chains become a concern)
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.015 seconds with 17 queries. (Pretty URLs adds 0.001s, 0q)