Pages: [1]
Author Topic: Help address Map sensor limiter Med 9.1  (Read 4539 times)
emma
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 24


« on: May 14, 2014, 12:35:21 PM »

Hello to all
I need to figure out if the sensor Map of my car has arrived at full scale because after several tests I can not come up with the turbo pressure more than 2.1 bar someone i can tell the address of the maps of the Map and if anyone knows what modificxare over you limitatoti pressure and load, torque, etc.?

Map file ori:
Logged
fredrik_a
Full Member
***

Karma: +25/-0
Offline Offline

Posts: 221


« Reply #1 on: May 14, 2014, 09:11:24 PM »

I can not come up with the turbo pressure more than 2.1 bar

Are you really running 2.1 bars of boost (3.1 absolute)?
Logged
emma
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 24


« Reply #2 on: May 14, 2014, 10:11:25 PM »

Are you really running 2.1 bars of boost (3.1 absolute)?
Tanks fredrik_a
But my car has 2.1bar absolute,1.1 bar of boost
Logged
technic
Full Member
***

Karma: +18/-5
Offline Offline

Posts: 227


« Reply #3 on: May 15, 2014, 12:50:21 AM »

Your problem is not related to diag limiter. It's limited by sensor to 2550mBar (at least).
Logged
terminator
Sr. Member
****

Karma: +15/-4
Offline Offline

Posts: 425


« Reply #4 on: May 15, 2014, 01:33:09 AM »

Probably you missed LDPBN
Logged
emma
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 24


« Reply #5 on: May 15, 2014, 01:44:47 AM »

Probably you missed LDPBN
thanks for the reply
but LDPBN it was increased to 2500
I am attaching the modified file so that you can control it

This file is one of many files tested but without result

Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.015 seconds with 17 queries. (Pretty URLs adds 0s, 0q)