Pages: [1]
Author Topic: Innovate LM2 rpm issues on 1.8t  (Read 5252 times)
aef
Hero Member
*****

Karma: +70/-46
Offline Offline

Posts: 1604


« on: July 01, 2014, 02:08:58 PM »

Hi,

i logged my 1.8t AGU (M3.83) with the Innovate LM2 hand held device and used the ecu-to-cluster RPM Signal.
What can cause this rpm issues. Its the black line with flat tops and drops.


« Last Edit: July 01, 2014, 10:44:59 PM by aef » Logged
aef
Hero Member
*****

Karma: +70/-46
Offline Offline

Posts: 1604


« Reply #1 on: July 01, 2014, 10:45:47 PM »

here is the missing image...
Logged
eliotroyano
Hero Member
*****

Karma: +48/-9
Offline Offline

Posts: 826


« Reply #2 on: July 02, 2014, 10:21:44 AM »

Hi,
i logged my 1.8t AGU (M3.83) with the Innovate LM2 hand held device and used the ecu-to-cluster RPM Signal.
What can cause this rpm issues. Its the black line with flat tops and drops.

I have a similar connection but with an Innovate SSI4, and I used a 2KOhm resistor as pull-up to clean the signal and have the best shape possible. I confirm it with an oscilloscope. Did you use or try with it?
Logged
aef
Hero Member
*****

Karma: +70/-46
Offline Offline

Posts: 1604


« Reply #3 on: July 02, 2014, 10:41:53 AM »

I just update the Innovate Firmware and will try the 2kohm resistor aswell.

Thank you sir!
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.029 seconds with 17 queries. (Pretty URLs adds 0s, 0q)