Pages: [1]
Author Topic: Gelletto Help, cant read ecu or get data.  (Read 5736 times)
fueledpassion109
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 4


« on: June 03, 2011, 10:10:50 PM »

I have read 100's of threads about galletto and putting my car in boot mode. after 2 days of trying i figured I ask for help.

I have a 2001 WBE Jetta 1.8t

removed fuse 11 and 15
I soldered 1k ohm to pin 24-connected to mass,
turned ignition to on.
waited 5 seconds removed ground,
started galletto 1260
tried to get ECU Data but got error Boot mode inactive.



ECU:

06A906032 DL
BENZIN ME7.5 0003
26SA7257 1159 0122
MOTRONIC 00-12-05



Any thoughts?
Logged
vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #1 on: June 04, 2011, 01:01:30 AM »

I don't remember anything about using a resistor on pin 24. Did you try straight to ground?
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
fueledpassion109
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 4


« Reply #2 on: June 04, 2011, 10:32:16 AM »

yes, I have tried straight.

Logged
fueledpassion109
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 4


« Reply #3 on: June 04, 2011, 11:00:35 AM »

so grounded to batt. and now i get a new error... errore ecu data....

Logged
vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #4 on: June 04, 2011, 02:37:30 PM »

I usually remove the ecu when doing a boot mode on the 06A ecu's. I don't have any exp doing them while still in the car. Hopefully someone else on here may be able to help.
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 16 queries. (Pretty URLs adds 0s, 0q)