Hi everyone

Having read through loads of the posts on here (very informative)  I've found answers to lots of questions regarding reading, flashing etc, but would appreciate a little help on this one.

I have a Galletto 1260 (which i know know to be a clone ) and a tuned file for a 2001 Octavia VRS, AUQ 180 engine.
I can connect to the ECU and get it to read the basic data, but when I try and save the existing map file it brings up 'ERRORE READID' and doesn't save anything.

I'm using the 29F400BB driver although mine is reading as 29F400BT (think I've read that this isn't an issue).

I think the previous owner had a Revo trial put on the car.....could this be blocking the read

Its highly likely that I'm not using the lead correctly, but would it be better to use the Nefmoto software and the right lead get past this??

Thanks in advance

I'm certain ODB reading will be blocked by the trial, if it is indeed there.

The best way is to try NefMoto with the KKL cable and see what happens. At the very least you should be able to flash over it with a stock file so you at least know what you're dealing with. Doing that with Galletto clone carries associated risk which is almost zero with Nefmoto due to it's 'sector at a time' flashing method.

In any case there are a few of us AUQers  here so welcome.

Do you know the ECU / Firmware numbers?