I recently followed the s4wiki to set MSLUB/MSLBAS on my M/L box and was able to allow the SAI readiness to run and pass.

However, the same definition shows a small offset with your BIN. Is the 551T bin you attached from a A6 by any chance?

See screenshot for the offset:



Attached is the M-box definition I used (based on the standard M definition from the wiki) plus a few other things like "dwell time" if you're running 2.0T coils.

Thanks for moving this nyet.

I was worried that my reply would be off-topic since the OP's bin attached doesn't appear to be a M-box which is what the stage 1 project is really aiming for.

This is what I'm looking at now. For some reason the address offset for battery voltage shifted -4 when I opened up my XDF axis values right now are 0.0    0.0    .7       3.52        7.05          10.57      14.09        17.62 for MSLUB

Also I've found CDSLS at 181b0 but have yet to find one XDF or ols map pack with CWKONABG on any ecu to give me a general idea of where it would be. if anyone can give me a tip that would be great. Appreciate all the help guys as usual