Which cell would I change?

Pages: [1]

« previous next »

Author

Topic: Which cell would I change? (Read 3837 times)

Billy

Newbie

Karma: +0/-0
Offline

Offline

Posts: 14

	Which cell would I change? « on: December 16, 2014, 09:04:37 AM »

As an example, if i wanted to increase the timing at a load of 170 but the axis data is 160 then 180, which cell is best to make the change, the 160 or 180?


	Logged

!nfern0

Full Member

Karma: +10/-1
Offline

Offline

Posts: 91

Audi TT 1.8T BAM

	Re: Which cell would I change? « Reply #1 on: December 16, 2014, 10:18:45 AM »

Usually the values are interpolated. So i would change both. Wink


	Logged

sweegie

Full Member

Karma: +10/-2
Offline

Offline

Posts: 137

	Re: Which cell would I change? « Reply #2 on: December 16, 2014, 10:27:31 AM »

As above... Unless you rescale the axis, the only way to change the interpolated value at 170 is to change the 160 and 180 values.


	Logged

vwaudiguy

Hero Member

Karma: +53/-37
Offline

Offline

Posts: 2024

	Re: Which cell would I change? « Reply #3 on: December 16, 2014, 01:29:11 PM »

I would say it also depends on what you have on either side of the two cells. You still want the transition to be smooth. Say you want 10 degrees at 170..8 at 160 and 12 at 180. Also shouldn't be too hard to re-scale the axis.


	Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

November 22, 2024, 05:56:23 AM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search