Pages: 1 [2]
Author Topic: 14 point seven spartan wideband install  (Read 11607 times)
zillarob
Full Member
***

Karma: +13/-1
Offline Offline

Posts: 152


« Reply #15 on: January 09, 2015, 10:29:21 PM »

You use the power, the ground, or both?

That last one did seem to read a little on the high side at idle with me7logger (zt3, 0.009766, -9.6).

The next one has a zt2 with the digital gauge and sits at 14.7 at idle.
Will have to grab some logs to see if they differ between zt2 hardware and me7logger on this one.
Logged
stuklr
Full Member
***

Karma: +2/-0
Offline Offline

Posts: 147


« Reply #16 on: January 10, 2015, 08:08:17 AM »

Julex found that the Spartans signal is distorted when connected to the ecu. His values seem to be spot on so far.

http://nefariousmotorsports.com/forum/index.php?topic=3731.120
Logged
kingkhalilz
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 123


« Reply #17 on: January 10, 2015, 12:06:00 PM »

Julex found that the Spartans signal is distorted when connected to the ecu. His values seem to be spot on so far.

http://nefariousmotorsports.com/forum/index.php?topic=3731.120


I think this is irrelevant because the signal wire is always wired to the 02 plug. not get 0-5v is independent of the wiring because DD was not getting 0-5v either. Good look tho, might need to use that correction to get an accurate reading.
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.017 seconds with 17 queries. (Pretty URLs adds 0s, 0q)