OK so all my friends own Mk4 GLI's and 20th's.


I cannot seem to get a spare 5 speed 032DL ecu with immo removed to work with 6 speed 032RN programming or a DL flash on a RN ecu.
The DL ecu with DL software will run in the GLI or 20th and the RN ecu with RN software will run in a jetta/golf/xxxxx...immo defeated of coarse.

I tried bench flashing via galletto. Bench and OBD2 via mpps. OBD2 via Nef. no combo works.


I end up flashing the RN ecu back with RN software via bench galletto and it fires right up.

Even if both ecu's have the same eeprom immo removed bin file?

I have a bad TB RN ecu but the flash is still good. Might have had a tuner defeat this ecu already i cant not remember. Ill pull in the RN eeprom info.

I guess I do not understand this. Clone immo3 ecu eeprom to immo2 ecu eeprom?

I am trying to understand this. Buddy of mine has immo 2 tdi car and is using an immo3 tdi ecu with just an immo defeat and has no issue.

Do you mean the cluster immo data?

I guess what I do not understand is that both ecu's have the same eeprom immo off file with no vin/cluster/immo id data.

I do not have the original eeprom file. It was lost when my netbook hdd died. Now everything gets saved in the cloud.

Would it work if I pulled the eeprom bin from a non immo defeat RN ecu and only turned off immo?


I might have the 1st original non RN immo defeated ecu, but it does not power up. The 2nd RN ecu was re-flashed and immo defeated by a big brand tuner.....then a week later the rear o2 was shorted out killing the throttle. I bought that car to part out. I could remove the original 95040 chip and put it on the semi working ecu to pull eeprom info?