R32VAG
Newbie
Karma: +0/-0
 Offline
Posts: 20
|
 |
« on: May 04, 2015, 07:17:25 AM »
|
|
|
Hello,
now i have a big trouble,
yesterday i try to read out my ME7.1.1G from a Golf V R32 in boot mode. This was not possible. I try it some times.
So i put the ecu back into the car. Now the car wont run normaly. Sometimes the car need a long time to start the engine. Then the engine runs at 100rpm. When i pull the gas down the rpm goes up and the machine runs normaly at 700rpm.
Then i can drive normaly!
The Fan is also running permanently.
I read out the ecu with VCDS. There shown some failures.:
Internal Control Module - Memory Check Sum Error
Enginge Coolant Temp. Sensor (G62) Implausible Signal
Air Intake Temperatur Sensor Implausible Signal
When i go to the Measuring Blocks:
Air Intake Temperatur is still -16 Celcius
Coolant Temperature is still -1.0 Celcius
Whats the Problem??
May i bricket the eprom flash chip?
Sorry for my bad english, i hope you can unterstand it.
|
|
|
|
|
Logged
|
|
