hello to everyone. Nice and helpful group.

I have convert an AGU converted to BAM. I change all sensor turbo manifold injector and coils. This engine is in a '92 Corrado. The result is that I have some faults for the stuff is missing and this causing me a safe mode. I would like some help to remove this faults so the car can run as it should. These are the stuff missing and giving me the faults.

ABS
Airbag
VVT because my actual engine is AGU without one
EVAP
Catalyst
after catalyst O2 and
recirculation valve (blowoff Valve)

Anyone here can help me with this faults?

Also I would like to know in what bytes I canfind the Esconf and how is coded in this ECU.
Attached is my bin file.

Thanks in advance.

Dear aef thanks for the help. I already read and learn a lot from s4wiki but I loose the solution in front of my eyes.
I'm not sure about the CW_CAN_R location.As I find from the winols project is at 101A*? I need to remove cluster abs and airbag too.


Now what about checksum is the ME7Check Ok for that ECU?

After check I will be write it back to   ecu and I will be OK? Is there anything I have to do before upload

Thanks for everything.

I think I'm fine the only part I'm still looking is how I can modify the CAN. I need to remove this 3 faults and I'm done.
18057 - Powertrain Data Bus
            P1649 - 35-00 - Missing Message from ABS Controller
17931 - Crash Signal from Airbag Controller
            P1523 - 35-00 - Implausible Signal
18058 - Powertrain Data Bus
            P1650 - 35-00 - Missing Message from Instrument Cluster