Pages: [1]
Author Topic: ME 9.1 Immo Issues after bdm flashing  (Read 3584 times)
R32VAG
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 20


« on: July 13, 2015, 01:15:39 AM »

Hello,

read out the flash, modified it and write it back again to the ecu over obd. Checksum checked by winols and galletto during writing. I think its correct.
After reinstalling the ecu to the car there are Immobilizier active in the dash and the car starts, runs shortly an then the engine getting of again.
Failure in the ECU are only 005642 - P160A-004

Whats the problem? I have read out the immobilizer dump over bdm already
The car is an golf 5 gti.
Can anyone read out the pin code from the dump?
Logged
aef
Hero Member
*****

Karma: +69/-46
Offline Offline

Posts: 1583


« Reply #1 on: July 13, 2015, 02:47:45 AM »

http://www.evc.de/en/service/q1608.asp

and there is a tag in your file.
i think you are not a member of this company  Shocked
Logged
R32VAG
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 20


« Reply #2 on: July 13, 2015, 02:52:27 AM »

How can i fix it??

On the ecu was an Tuning File from BTS. But we have to changed some mappings. So we write the new one but not the problem with the immo.
Logged
de_Fre
Jr. Member
**

Karma: +7/-2
Offline Offline

Posts: 25


« Reply #3 on: July 14, 2015, 07:28:06 AM »

Do a BDM read of the Flash (as it is now) and send it to someone who can and is willing to help together with the OBD read you took before you remapped it.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.015 seconds with 16 queries. (Pretty URLs adds 0s, 0q)